Harmar AL425 Axis II Powered Inside-Vehicle Hoist

The AL425 Axis II is an interior hoist for loading a compatible manual wheelchair, power wheelchair or scooter into a van, SUV or truck. Harmar powers the lift and rotation so the unoccupied mobility device can be moved into the vehicle's cargo area instead of riding on an exterior hitch platform. Harmar says the inside-vehicle layout can preserve use of the backup camera. The trade-off is that the lift and device share the vehicle interior with passengers and cargo, so fit and loading geometry need to be confirmed before ordering.

Capacity and Device Compatibility

The standard AL425 supports devices up to 400 lb. Compare the device's actual weight, length, width and height with the vehicle opening and the hoist's reach. A device under the capacity limit can still be too large for the cargo area, interfere with trim or seats, or fail to align with the intended securement. Confirm the device model, required attachment and any accessory-specific hardware with a Harmar dealer rather than assuming the capacity rating proves fit.

Powered Lift and Rotation

The powered lift raises the mobility device and rotates it into the cargo area. This can change the loading routine compared with a hitch platform, but it does not remove the need to guide and secure the device correctly. Keep the device unoccupied while it is being lifted and transported. Follow the AL425 manual for controls, lifting, rotation, securement and emergency procedures, and the mobility-device manufacturer's instructions for any approved attachment points.

Vehicle-Specific Fit and Access

Harmar lists the AL425 for vans, SUVs and trucks, but the exact vehicle interior determines whether it will fit. Check available headroom, cargo depth, door opening, mounting location and the path through which the chair or scooter rotates. Consider how the loaded device affects passenger seating, luggage and access to the rear of the vehicle. Measure the actual vehicle and mobility device together; a model category alone is not a fit confirmation.

Installation and Transport Planning

Confirm the mounting structure, vehicle clearances and securement setup before installation. Check the AL425 rating along with the vehicle's payload and any relevant mounting limits, and arrange qualified installation where required. Because the device travels inside, the remaining cabin space and backup-camera view should be checked after the lift and device are in their travel positions.

Before Ordering

Provide a Harmar dealer with the vehicle year/model, mobility-device model and dimensions, and the intended passenger/cargo arrangement. Confirm the required hardware, installation and loading sequence against the current manual. The AL425 carries an unoccupied mobility device; it is not a passenger lift.